![]() ![]() In most cases it supersedes the older Juniper Network Connect. This can be imported into the Device Studio under "Manage Pollers" in NPM 10.7 or higher (poller was created under 11.0). Support for Pulse Connect Secure was added to OpenConnect in June 2019, for the 8.04 release. Following that, you will need to manually select this poller for applicable nodes that aren't returning any information of course, which can be done from a Node's "List Resources" (or you can switch the behavior in "Manage Pollers" as well). Note: After importing, you may want to set this poller to Off for automatic scanning and let the SolarWinds native poller try first. (Least that was the case in my environment - some devices worked with the native, others didn't, until I created this one.) If you aren't getting CPU & Memory natively, you may find you're able to get it by switching to this poller. Open the settings of the Juniper Networks Virtual Adapter Enable the Juniper Network Service network binding Since the virtual network card is automatically removed if the connection is not successful and then loses the setting, I have automated the steps via PowerShell. and while SolarWinds now has native support for Juniper devices, depending on your actual hardware and/or software version, Orion/NPM may not pickup the information (you'll still likely see Neoteris show up as the MachineType). ![]() Custom device poller to provide CPU & Memory polling for select Juniper Pulse (Neoteris) units.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |